Effect Of Manufacturing Techniques On Adaptation Of Removable Partial Denture Frameworks In Mandibular Kennedy Class I cases: An In Vitro Comparative Study

Document Type : Original Article

Authors

1 Ass. Lecturer at Prosthodontic Department, Faculty of Dentistry, Minia University.

2 Professor at Prosthodontic Department, Faculty of Dentistry, Minia University

3 Lecturer at Prosthodontic Department, Faculty of Dentistry, Minia University

Abstract

Introduction: Removable partial dentures (RPDs) are considered an economic and good treatment modality compared with most costly alternatives like dental implants. CAD/CAM technology has improved the fit of RPDs, improving efficiency and manufacturing results.
Aim of this study: This study was conducted to compare adaptation between 3D printed frameworks and conventionally constructed ones in mandibular Kennedy class I.

Materials and methods: A model of mandibular Kennedy class I was used. A total of 12 frameworks were constructed over the model and divided into 2 groups. Six frameworks in each group according to fabrication method: Group I, 3D printed metal frameworks; Group II conventional method (Lost-wax technique). RPD frameworks were constructed from cobalt-chromium alloy. The frameworks were optically scanned, and the distances from the original master model at various points were measured for adaption comparison.
Results: Group I showed less deviation in comparison to Group II with a statistically significant difference (p-value <0.05).
Conclusion: Within the limitations of this study it was concluded that:
The 3d printed manufactured frameworks showed higher adaptation and fitness, with smaller discrepancies relatively to that frameworks conventionally constructed by casting technique.

Keywords

Main Subjects

Egyptian Dental Journal
Volume 70, Issue 4 - Serial Number 4
Fixed Prosthodontics, Removable Prosthodontics and Dental Materials
October 2024
Pages 3593-3600

Files

Share

How to cite

Statistics